Silver Jinn Studios, Your source for the alternative.
Cart 0

Sizing & Fitting Guide

 Ring Size Guide

How To Measure Your Ring Size

1. Cut a strip of paper no wider than 6mm.

2. Wrap the paper around your finger, and mark the paper where it meets.

3.Check that it slips over the joints of the finger without difficulty.

4. Measure the marked length of paper and compare it to the metric row in size chart.

This should give you a good idea of your ring size.

If your ring falls between sizes, order the next larger ring size.

 

 

PLEASE NOTE that ring sizes may vary due to our jewelry being hand made

-------------------------------------------------------------------------------------------------------------

--------------------------------------------------------------------------------------------------------------

 

Watch Setting Guide

Below, are some simple pictures to assit you with setting the time, or changing the battery on your Alchemy watch. 

If you have any questions about this process, please do not hesitate to contact us.

Step 1. 

Remove the watch face, by gentle and carefully prying it from the pewter fitting.

 

Step 2.

At this step you can either set the time on your watch face using the below instructions, or move to Step 3 to replace your battary.

Setting the Time: Gently pull the small, round dial out from the side of the watch face.  Gently twist the dial to set the time and push back into place.

Changing the Battery: We strongly suggest that you take your watch to a qualified jewelers to change your battery.  If you wish to do this yourself, please follow Steps 2,3 & 4.  You will need to use a watch fitting tool to remove the back of the case from your watch, as show below.

 

Step 3.

Once you gently pry open the back of the watch fitting, you can remove the back panel completly.  Please note, there is a small cut out, for the time setting dial, on the side of this back panel.  When you are ready to replace and close this back panel, you will need to match this cut out up with the dial.

 

Step 4.

To replace the battery, remove from the back of the fitting and replace new battery.  Then gently push the back panel back on (remembering to line up the dial cut out).